ADLER AD 5044 2 in 1 Garment Steamer & Iron User Guide

ADLER AD 5044 2 in 1 Garment Steamer & Iron

GENERAL SAFETY CONDITIONS IMPORTANT

Before using the device, read the instruction manual and follow the instructions contained therein. The manufacturer is not responsible for damage caused by using the device contrary to its intended use or improper operation.

1. The device is for domestic use only. Do not use for other purposes incompatible with its intended use.
2. WARNING: Before connecting the appliance plug to the power outlet, check the voltage of the power supply and set the switch to the correct position. It is forbidden, to change the position of the voltage switch, during operation of the device Connect the appliance only to a grounded outlet 220-240V ~50/60Hz or 110V-120V ~ 50/60Hz, to increase the safety of use, multiple electrical appliances should not be connected to a single circuit at the same time.
3. Be especially careful when using the device when children are around. Do not allow children to play with the appliance. Do not allow children or people who are not familiar with the appliance to use it.
4. WARNING: This equipment may be used by children over 8 years of age and persons with limited physical, sensory or mental ability, or persons without experience familiarity with the equipment, if this is done under the supervision of a person responsible for their safety or they have been given instructions on the safe use of the equipment and are aware of the dangers associated with its use. Children should not play with the equipment. Cleaning and maintenance of the equipment should not be performed by children unless they are over 8 years of age, and these activities are performed under supervision.
5. WARNING: Use caution when using the equipment due to steam emissions.
6. WARNING: The fabric steamer and its power cord should be out of the reach of children under 8 years of age when the appliance is on or cooling down.
7. WARNING: The fabric steamer must not be used if it has been dropped, if it has visible signs of damage, or if it is leaking water.
8. WARNING: The fabric steamer must not be left unattended while it is connected to the mains.
9. Always remove the plug from the power outlet after use by holding the outlet with your hand. DO NOT pull on the power cord.
10. Do not immerse the cord, plug, or the entire unit in water or other liquid. Do not expose the unit to weather conditions (rain, sun, etc.) or use it in high humidity conditions.
11. Periodically check the condition of the power cord. If the power cord is damaged, it should be replaced by a specialized repair facility to avoid danger.
12. Do not use the device with a damaged power cord or if it has been dropped or damaged in any other way, or malfunctions. Do not repair the device yourself, as there is a risk of electrocution. Return a damaged device to a competent service center for inspection or repair. Any repairs may be made only by authorized service centers. Improper repair may cause danger to the user.
13. Place the appliance on a cool, stable, level surface, away from hot kitchen appliances such as an electric stove, gas burner, etc.
14. Do not use the device near flammable materials.
15. The power cord must not hang over the edge of the table or touch hot surfaces.
16. To provide additional protection, it is advisable to install in the electrical circuit, a residual current device (RCD) with a rated residual current of not more than 30 mA. In this regard, consult a specialist electrician.
17. If it is necessary to use an extension cord, use only one with a grounding pin and suitable for the load, not less than the load connected to it. Other (“weaker”) Extension cords may overheat. Arrange the cable to avoid accidental pulls or tripping over it.
18. Always, before filling the iron with water or when the iron is not in use, disconnect it from the power supply.
19. Touching a hot foot, contact with hot steam or water risks burns. Be careful when you turn the iron upside down with the foot, as there may still be hot water in the reservoir, even when the iron is unplugged.
20. DO NOT allow the hot iron to come into contact with fabrics or flammable materials for too long.
21. Be careful that the power cord does not come into contact with the hot iron foot.
    Allow the iron to cool completely before putting it away.
22. If you do not use the iron even for a short time, turn off the steam options.
23. Do not, under any circumstances, iron clothes or materials on people or animals.
24. Never direct the steam onto people or animals.
25. Use the iron on a stable level surface and only put it down on such a surface.
26. Do not pour water with chemical additives, fragrances, or descaling preparations into the tank.
27. Do not fill the water tank above the MAX level.
28. The power plug must be unplugged from the power outlet before filling the tank with water (for steam humidification irons and irons with a washer.
29. The power plug must be removed from the power outlet before cleaning the
30. machine. The opening for filling the water tank must not be opened during ironing.

Description of the device

1. Water tank cover
2. On/off switch for steam control
3. Steam ejection button
4. Locking the steam ejection button
5. Power cord
6. Water tank
7. Ceramic foot
8. Power indicator light
9. Display
10. Attachment to the brush

First use

When using the iron for the first time, you may notice a slight emission of smoke and hear sounds coming from the plastic. This is quite normal and stops after a short time. A small amount of water may remain in a brand-new iron after a routine leak check of the product. Filling with water. Before filling (or draining) the iron with water, unplug it from the power outlet.

1. Open the water tank cover (1) and turn the iron at a 45 ° angle.
2. Fill the water tank with water to the “MAX” level.
3. Close the water tank cover. Steam ironing function: Fill the tank with water as described in “Filling with water”.
4. Plug the power cord of the machine into the power outlet, and the power light (8) will light up.
5. Press the SET button (2) of the device will turn it on. The display (9) will start counting down from 9 to 0. When the iron reaches the maximum temperature, the display will show 0. Heating time: 20 seconds.
6. Set the degree of steam ejection power by pressing the SET button (2) once – the display will show 1, twice, the display will show. For the device to start emitting steam, press the button (3) of steam ejection and hold it. It is possible to lock the button to continuous steam ejection; for this purpose, you need to move the lock (4) downwards, which is located in the button (3).
7. To stop the steam ejection, move the lock (4) in the opposite direction.
8. After use, hold the SET button (3) for 3 seconds; the device will stop heating, then remove the plug from the power outlet.
9. After each use, make sure the water tank is empty.
10. Note: Do not use the steam ironing function on clothes or fabrics worn by people or animals. The temperature is too high. Vertical steam ironing function: The vertical steam ironing system allows you to use the iron to iron vertically. This is especially useful for removing creases from hanging clothes, curtains. Fill the tank with water as described in “Filling with water”.
11. Plug the power cord of the appliance into the power outlet the power light (8) will light up.
12. Press the SET button (2) of the device to turn it n. The display (9) will start counting down from 9 to 0. When the iron reaches the maximum temperature, the display will show 0. Heating time: 20 seconds.
13.  Set the degree of steam ejection power by pressing the SET button (2) once – the display will show 1, twice, the display will show.
14. Hang the clothes on the clothes rack and tighten them with one hand.
15. Hold the iron in an upright position with the other hand and press the steam ejection button (3) and hold it, it is possible to lock thebutton tooo continuous steam ejecti;n, for this purpose, you need to move the lock (4) downwards, which is located in the button (3). Touch the clothing lightly with the iron to remove creases.
16. To stop the steam ejection, move the button lock (4) in the opposite direction.
17. After use, hold the SET button (3) for 3 seconds; the device will stop heating, then remove the plug from the power outlet.
18. After each use, make sure the water tank is empty.
19. Note: Do not use the steam ironing function on clothes or fabrics worn by people or animals. The temperature is too high. Auto shut-off system
20. The electronic safety ADLER AD 5044 2 in 1 Garment Steamer & Iron device will automatically turn off the heating element, if no button of the device is pressed for 5 minutes, the product will be automatically turned off. The power light (8) will start flashing, and the unit will stop heating.
21. To turn the unit back on, press the SET button (2).

Note: During use or when the unit is heating or cooling, place the product in a flat, stable, and resistant to heat. After ironing, unplug from the power outlet and wait for it to cool down. To prolong the life of the iron, it is recommended to empty the tank as follows after ironing: Unplug the iron from the power outlet. Empty the iron by opening the lid of the water tank and holding it with the tip facing down. Shake it lightly over the sink, then close the lid. Clean the foot of the iron with a dry cloth to remove traces of moisture. Cleaning and maintenance. Before cleaning, unplug the iron from the power outlet and wait for the iron to cool down sufficiently.

1. Wipe the foot with a damp cloth and a non-abrasive (liquid) cleaner.
2. If the fiber is stuck to the iron foot, use a damp cloth with vinegar to wipe the iron foot.
3. Never use strong acid or alkali to avoid damaging the iron foot.

TECHNICAL SPECIFICATIONS

• Voltage: 220-240V ~ 50/60Hz
• Power: 1400W – 1800W

For the sake of the environment. Dispose of cardboard packaging and polyethylene (PE) bags in the appropriate containers for separate collection of municipal waste according to their description. If there are batteries in the device, remove them and separately return them to the collection and storage facility. Return the used device to a suitable ADLER AD 5044 2 in 1 Garment Steamer & Iron collection and storage facility, as the hazardous substances in it may pose a threat to health and the environment.

The marking on the product indicates that the device should not be disposed of in the container with municipal waste. Waste electrical equipment is waste that contains substances harmful to humans, animals, and the environment.

These substances can lead to contamination of the soil, water, or air, and through this, they can enter the human body and lead to numerous health ailments, such as vision, hearing, and speech disorders. They can also damage the kidneys, liver, and heart, and cause skin diseases.

Harmful substances can also have adverse effects on the respiratory and reproductive systems and lead to cancerous changes. Consumption of plants growing on the contaminated soils and products made from them may risk the above-mentioned health effects. Do not dispose of the device in the
municipal waste container!!! If you wish to purchase spare parts or report any complaints, please contact directly with the seller who issued the receipt directly.

FAQs

How do I use the ADLER AD 5044 as a garment steamer?

Clean tap or distilled water should be added to the water tank until the maximum line is reached. Plug the gadget in, attach the steaming head, and turn it on. Await the indicator that is ready. To get rid of wrinkles, hold the steamer upright and gently move it over clothing.

How do I use the ADLER AD 5044 as an iron?

If the ironing plate isn’t already attached, attach it now. If you want to use a steam iron, fill the water tank. Iron clothing on a level surface after choosing the temperature setting that works best for your fabric and waiting for the machine to warm up.

Can I use tap water in the steamer/iron?

You can use tap water, yes. To avoid limescale accumulation, which can impair performance and harm the unit, it is advised to use distilled water if your water is difficult to use.

How long does it take to heat up?

Depending on the setting and water volume, the gadget usually takes 30 to 60 seconds to heat up. When it’s ready for use, the readiness indication light will turn on.

Can I use the steamer on delicate fabrics like silk?

Indeed. To prevent water stains, use the steaming mode on your clothing while keeping a safe distance. Always start with a modest, concealed area.

Can I steam or iron clothes while they are hanging?

Indeed, the steamer works well for hanging suits, curtains, and clothing. For optimal performance, iron on a level surface at all times.

Does the AD 5044 have automatic shut-off?

Indeed. To ensure safety and energy economy, the gadget will automatically turn off if it is left idle for a number of minutes or if it overheats.

How do I refill the water tank during use?

Unplug and turn off the gadget. Before taking the tank out and filling it up again, let it cool a little. Before using it again, make sure it is firmly attached.