Honeywell CO30XE Portable Evaporative Air Cooler
PARTS DESCRIPTION
- Control Panel
- Handle
- Louvers
- Water Tank
- Power Cord & Plug
- Casters
- Ice Compartment Lid
- Rear Grill
- Water Level Indicator
- Remote Control
- Detachable Water Tank Latch
- Water Fill Door
- Drain Plug
- Water Regulator
USE & OPERATION
CONTROL PANEL
FUNCTION BUTTONS
POWER
Press the button to turn the unit on. The cooler will start automatically at medium speed. After a few seconds, the speed will switch to low. To turn the unit off, press the button again.
SPEED
Press the SPEED button repeatedly to change the speed between High, Medium, and Low. The indicator light will show the selected speed.
COOL
Press the COOL button until it is illuminated on the display screen. This activates evaporative cooling.
WARNING
Please ensure sufficient water is in the water tank; otherwise, you may hear a Low Water Alarm, and the cooler will start in a Fan-only mode without evaporative cooling.
TIMER
Press the TIMER button until the desired time duration setting is selected. When the set time has passed, the unit will automatically turn off (unit remains in Standby mode until the power cord is unplugged from the lectrical socket). The TIMER function allows you to program the unit for up to 7.5 hours of use.
SWING
Press the SWING button until it is illuminated on the display screen. The louvers will begin to move left to right automatically. Vertical Air Flow – You can manually adjust the louvers to change vertical air flow.
NATURAL
Press the NATURAL button until it is illuminated on the display screen. The fan will randomly change between High, Medium, and Low speeds to mimic a natural breeze.
ROOM COOLING AND HUMIDIFYING
In cooling mode, Honeywell Air Coolers provide cool, moist air through the evaporation of water. There is a manual Water Regulator knob located in the ice compartment of the unit. This allows you to adjust the amount of water pumped over the Honeycomb Cooling Media, thus helping to control cooling and humidification levels. This results in maximum water evaporation and greater cooling performance.
REMOTE CONTROL
- POWER: ON / OFF
- SPEED: Low / Medium / High
- COOL: Controls cooling or fan option
- SWING: Controls the motion of the louvers
- TIMER: Controls the Timer function for automatic off
- NATURAL: Turns on Natural mode
Note
- The remote control requires AAA (2 x 1.5V) batteries for replacement.
- Open the battery compartment at the back of the remote control and insert the batteries inside. Care
must be taken to insert the batteries according to the correct polarity (+ / –) markings shown inside
the battery compartment.
COOLER LOCATION
Make sure to position the air cooler correctly before you set up and start using the product. Please refer to the COOLER LOCATION section of the separate Safety & Maintenance Guide.
FILLING WITH WATER
CAUTION
Unplug the unit from the electrical power outlet before emptying or refilling the water tank.
Open the Water Fill Door located on the side of the unit.
The Water Level Indicator is located on the side of the unit. Refill the water tank when the water level is low. Do not fill water above the “Max.” water level mark to avoid water droplets collecting on the louvers. Check the water level in the tank before running the COOL function. Make sure that the water in the tank is above the minimum water level mark. Running the unit in COOL mode with inadequate water may cause pump failure.
Note
- The water capacity refers to the total volume of water that can be contained within the air cooler water tank and water distribution system. The water capacity in the tank at the “Max.” indicator level may be lower than the actual water capacity of the air cooler.
- If ice is available, you may add ice to the top ice compartment to enhance the cooling performance.
- Do not fill the water tank with dirty water or salt water. This can damage the unit and the Honeycomb media.
LOW WATER ALARM
The unit is equipped with a low water sensor. In Cooling Mode, when the water in the tank is below the
minimum level, you will hear a beeping sound and the screen will flash continuously. The unit will automatically pause evaporative cooling. Refill the water tank to deactivate the alarm in cooling mode. First, switch OFF the unit and unplug it ffrom thepower outlet. Fill the water tank with water above the minimum water level mark. Plug in and switch ON again. To deactivate the alarm and continue using the unit as a fan (without evaporative cooling), switch the unit OFF and then ON again. The Low Water Alarm will not activate in Fan-only mode. The Low Water Alarm will sound again if the COOL function is activated while the water tank is still empty.
CLEANING & DRAINING THE WATER TANK
Below are instructions on how to clean and maintain Honeywell CO30XE Portable Evaporative Air Cooler your air cooler. If the cooler will not be used for a long period, please refer to the STORAGE & MAINTENANCE GUIDELINES located in the separate Safety & Maintenance Guide.
WARNING
- Before cleaning the unit, switch the unit OFF and disconnect it from the electrical socket.
- Move the unit to a location where the water can be drained. Remove the cap from the Drain plug located at the bottom of the unit. Allow the tank to empty.
- Refill the water tank with clean water and drain it completely.
- Refill the water tank with clean water, up to the maximum level.
- Use a damp cloth to remove the dirt and dust from the surface of the unit. Never use corrosive elements or chemicals to clean this product.
- When the product is not in use, store the unit in a dry place out of direct sunlight.
Removing the Carbon Dust Filter
- Remove all the screws from the Rear Grill of the Air Cooler.
- Carefully pull out the rear grill from the cooler. Slide out the Carbon Dust Filter* and clean with water.
- The Honeycomb Cooling Media is secured on the Honeycomb Frame by a Horizontal Bar that is fixedin placee by two screws. Remove these two screws to release the Horizontal Bar and slide the Honeycomb out of the frame.
- Replace or clean media with water and a damp cloth as needed.
TECHNICAL SPECIFICATIONS
- Modl : CO30XE
- Product Dimension : 458 (W) x 352 (D) x 856 (H) mm 18.0 (W) x 13.8 (D) x 33.7 (H) in
- Net Weig : 11.3 kg / 24.9 lbs
- Voltage: 110 – 120V
- Frequency 60Hz
- Ampere: 2.4A
- Wattage :288 W
- Cooling Media : oneycomb
ELECTRICAL WIRING DIAGRAM
For USA Outdoor Models Only. This appliance is Honeywell CO30XE Portable Evaporative Air Cooler equipped with a GFCI plug. Press the TEST button and then the RESET button once every month to ensure proper operation.
Customer Service
- JMATEK North America LLC Mah,wah, New Jersey 07495 USA
- Phone: 1-800-474-2147
- Email: usinfo@jmatek.com
- Web: www.jmatek.com
- For Product video scan
