Primo PR407IB Portable Ice Cube Maker
Safety Instructions
- Children must not play with the appliance.
- Maintenance and cleaning of the appliance must not be done by children, unless they are older than 8 years of age and are supervised.
- Keep the appliance and cord out of the reach of children under the age of 8.
- If the electrical cord is damaged, it must be replaced by the manufacturer, its after-sales service, or a similarly qualified person to avoid any accident.
- Do not leave the cord hanging on a hot surface or over the edge of a table or countertop.
- Never use the appliance if the cord or plug is damaged, if the appliance has malfunctioned, or if the appliance is damaged. If so, take the appliance to the nearest qualified service center for inspection and repair.
- Close supervision is necessary when the appliance is used by or near children.
- Use of accessories not recommended or sold by the manufacturer may cause fire, electric shock, or injury.
- Unplug the appliance when not in use, before assembling or disassembling parts, and before cleaning the appliance. Turn all buttons to the “off” position and unplug at the plug itself. Never pull the cord to unplug the unit.
- All repairs other than the normal maintenance of the appliance must be performed by the manufacturer or its after-sales service.
- Never immerse the appliance, electrical cord, or plug in water or any other liquid.
- Keep children away from the electrical cord or appliance.
- Keep the cord away from sharp edges and hot parts or other heat sources.
- Before first use, remove all packaging materials and any promotional stickers.
- Do not tilt the device beyond 45°.
- Place the device at least 8cm away from other objects to ensure proper ventilation around the device.
- Do not turn the device on and off frequently in succession. Always leave at least a 5-minute interval in between to prevent damage to the compressor.
Components
- Water bowl
- Cooling fingers
- Ice scoop
- Sensor full basket
- Transparent lid
- Water container
- Drainage opening with a cap
Control Panel
- Refill water
- Ice basket full
- Make ice cubes
- On/off button
- Cleaning button
- The indicator will start flashing when the plug is plugged in. The appliance is now on standby. Use the ON/OFF button to turn the appliance on. The indicator will then remain lit.
- If the red light stays on the there is not enough water left in the water tank. Fill the water tank with water and press the ON/OFF button to restart the machine.
- If the light flashes, the ice basket is full. The machine will stop working. Empty the ice basket. When there is no more ice at the level of the sensor, the machine will restart automatically.
Before First Use
- Before using it for the first time, remove all packaging materials and any promotional stickers.
- Before using the ice cube maker for the first time, wait 4 hours after you put the unit in place and leave the lid open for at least 2 hours. This will allow the refrigerant to settle.
- Place the ice cube maker on a flat and stable surface and make sure the vents are not blocked.
- Clean the appliance before first use. See section: «cleaning and maintenance».
- Place the ice cube maker on a flat and stable surface and make sure the vents are not blocked.
- Open the lid and remove the ice basket from the appliance so that you can pour water into the water reservoir.
- Put the basket back in the appliance and close the transparent lid.
- Plug in the power cord and press the ON/OFF button to turn the appliance on.
- The indicator light lights up, and the machine will now start making ice cubes automatically.
- During the first 3 cycles, the ice cubes may be smaller and more irregular in size.
- If the ice basket is full, remove the ice immediately
Maintainance & Cleaning
The built-in clean function is designed to rinse the appliance inside. This is done by means of running water.
- Pour clean water into the water tank up to the MAX indication.
- Press the cleaning button. The indicator light will begin to flash. After a few seconds, the clean function will kick in.
- The clean function will run water through the device 5 times to rinse it optimally.
- The clean function then stops automatically.
- Remove the rinsing water through the drainage opening
Manua lCleaning
- Before cleaning, turn off the appliance and unplug it. Also, remove all ice cubes.
- Clean the ice basket, water reservoir, water tray, cooling fingers, and ice scoop regularly. Use a damp cloth with some mild detergent if necessary, to clean the inside and outside of the appliance. Rinse thoroughly before using the appliance again.
- Drain all water from the appliance through the drainage hole at the bottom of the appliance.
- Do not use chemicals or products containing acids, gasoline, or oil.
- Do not use mechanical devices or other tools to speed up the freezing process.
- If the unit has not operated for a long time, the light might stay on. In this case, press the ON/OFF button to return the unit to its normal state.
- Change the water in the water reservoir at least once a day to guarantee clean ice. When you are not using the appliance, immediately drain the water from the water tank through the drainage opening. This is to prevent contamination and algae formation in stagnant water. Always use fresh water when you use the appliance again.
Descaling
Descale the appliance regularly to prevent limescale build-up to keep the appliance operating properly. To do this, use a descaling agent for coffee makers, for example, or 1/2 vinegar diluted with 1/2 water.
Fill the water tank with the agent (do not exceed the maximum level) and turn on the appliance. Then press the clean function.
- The unit will now pump water through the entire unit. This cycle will repeat itself 5 times.
- The device will automatically stop rinsing after this..
Warranty
Should you nevertheless experience problems with your device, we sincerely regret this. In that case, we kindly request that you contact our customer service. Our staff will gladly assist you.
This appliance has a two-year warranty period. During this period, the Primo PR407IB Portable Ice Cube Maker manufacturer is responsible for any failures that are the direct result of construction failure. If your device breaks down within the 2-year warranty period, you can return the device together with your receipt to the shop where you purchased it. The guarantee on accessories and components that are liable to wear and tear is only 6 months.
The guarantee and responsibility of the supplier PRIMO PR130DV PR131DV PR132DV Freezer and manufacturer lapse automatically in the following cases:
- In case of incorrect connection, e.g., electrical voltage that is too high.
- In case of incorrect, rough, or abnormal use.
- In case of insufficient or incorrect maintenance.
- In case of repairs or alterations to the device by the consumer or non-authorised third parties.
Environmental Instructions
For more detailed information about the recycling of this product, please contact your local city office, your household waste disposal service, or the shop where you purchased the product.
Customer Support
- Tel: 800-728-5508
- Website: www.primo-elektro.be
- Timings: Monday – Thursday: 8.30 – 12.00 and 13.00 – 17.00, Friday: 8.30 – 12.00 and 13.00 – 16.30
FAQs
Q: What is the Primo PR407IB Portable Ice Cube Maker designed for?
Ans: Perfect for home bars, parties, camping, RVs, or workplace use, the PR407IB is a small countertop ice maker that automatically creates ice cubes in as little as 6 to 8 minutes.
Q: How much ice can it make in a day?
Ans: Depending on the water quality and room temperature, the PR407IB can generate up to 26 pounds (12 kg) of ice in 24 hours.
Q: What type of ice does it make?
Ans: This machine creates smooth, hollow, bullet-shaped ice cubes that are perfect for drinks. Some models come in two sizes: small and large.
Q: Does it need a water line connection?
Ans: Plumbing is not required. Just physically fill the tank with water, connect the device to a regular outlet, and it will begin producing ice on its own.
Q: How much water can the reservoir hold?
Ans: About 2.2 litres (0.58 gallons) can normally be stored in the water reservoir. For optimal effects, use cold, clean water at all times.
Q: Does the machine store the ice once it’s made?
Ans: It’s not a freezer, but it does have an interior ice basket. The ice will eventually melt and be recycled into the subsequent cycle of ice-making if it is not used right away.
Q: How will I know when the ice basket is full?
Ans: When the basket is full, the unit’s “Ice Full” indication light illuminates. Until some of the ice is removed, it automatically pauses.
Q: How do I know when to refill the water?
Ans: When the reservoir is empty, a “Water Low” sign will notify you. Refill with new water to start making ice again.