Palmer PAOCBXLRFXLR Female Audio Over Cat Box
Introduction
The Palmer PAOCBXLRFXLR Female Audio Over Cat Box ensures clean, balanced audio signals, even over long cable runs. The wupper Line Isolation Box is equipped with 6.3 mm jack sockets on the input and output sides, which can be operated both balanced and unbalanced. There is galvanic isolation between input and output by means of a high-quality transformer, and hum loops are reliably eliminated. The Line Isolation Box is perfect for balancing audio signals, and audio signals can also be transmitted over long cable runs without hum. For detailed setup instructions, you can also refer to the Palmer Wupper Line Isolation Box Instruction Manual.
Safety Instructions
Before using the Palmer PAOCBXLRFXLR Female Audio Over Cat Box, please follow these safety instructions carefully:
- Please read these instructions carefully.
- Keep all information and instructions in a safe place.
- Follow the instructions.
- Use the device in the prescribed manner only.
- Do not open the device and do not perform any modifications.
Packaging
- Packaging can be fed into the reusable material cycle using the usual disposal methods.
- Please separate the packaging in accordance with disposal laws and recycling regulations in your country.
Device
- This device is subject to the European Waste Electrical and Electronic Equipment Directive in the currently valid version.
- WEEE Waste Electrical and Electronic Equipment Directive. Old appliances do not belong in household waste.
- The old device must be disposed of via an approved disposal company or a municipal disposal facility.
- Please observe the applicable regulations in your country!
- Observe all disposal laws applicable in your country.
- As a private customer, you can obtain information on environmentally friendly disposal options from the seller of the product or the appropriate regional authorities.
Batteries
- Observe all disposal laws applicable in your country.
- As a private customer, you can obtain information on environmentally friendly disposal options from the seller of the product or through the relevant regional authorities.
The product is not suitable for
- Persons (including children) with limited physical, sensory, or mental abilities or a lack of experience and knowledge.
- Children (children must be instructed not to play with the device)
Connections
- INPUT
Line input with 6a.3 mm jack socket suitable for both unbalanced and balanced cabling. Use a shielded audio cable to connect, for example, a keyboard to the Line Isolation Box. - OUTPUT
Line output with a 6.3 mm jack socket suitable for both unbalanced and balanced cabling. Use a shielded audio cable to connect the Line Isolation Box to an input of a mixer or audio interface.
Wiring Example
Technical Data
| Product number | PWUPPER |
| Product type | Line Isolator |
| No. of channels | 1 |
| Type | passive |
| Transformer isolated | yes |
| No. of inputs | 1 |
| Input type | symmetrical/asymmetrical |
| Input connections | 6.3 mm jack |
| No. of outputs | 1 |
| Output type | symmetrical/asymmetrical |
| Output connections | 6.3 mm jack |
| Ground/lift switch | no |
| Housing | Aluminium continuous casting |
| Dimensions (H/W/D) | 110 x 50 x 50 mm |
| Weight | 0.3 kg |
| Ambient temperature for operation | -20°C…70°C |
| Relative air humidity | <80%, non-condensing |
| Included accessories AUDIO | Rubber feet, inscription label |
| Max. Input level (< 1% THD, 20 Hz) | +10 dBu |
| Max. Input level (< 1% THD, 1 kHz) | +32 dBu |
| Frequency response (±2dB, relative 1kHz) | 20 Hz – 20 kHz |
| Input impedance (1 kHz) | 17 kΩ |
| Output impedance (1 kHz) | 500 Ω |
| THD (30 Hz, +4 dBu, unity, unweighted) | < 0.09 % |
| THD (1 kHz, +4 dBu, unity, unweighted) | < 0.002 % |
| IMD (SMPTE) (60 Hz / 7 kHz, 4:1, +4 dBu) | < 0.002 % |
| Transformer ratio | 1:1 |
Manufacturer’s Declarations
Herstellergarantie und Haftungsbeschränkung Manufacturer’s warranty & limitation of liability Adam Hall GmbH Adam-Hall-Str. 1 61627 Neu-Anspach, Germany.
CE Conformity
Adam Hall GmbH hereby confirms that this product, Palmer Pan16 19“ DI-bo,x meets the following guidelines (where applicable): Low-Voltage Directive (2014/35/EU), EMC Directive (2014/30/E/U), RoHS (2011/65/EU), RED (2014/53/EU)
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
UKCA- Conformity
Hereby, Adam Hall Ltd. declares that Palmer Naab 2-Kanal Media DI-Bo,x this product, Palmer Pan16 19“ DI-bo,x meets the following guidelines (where applicable): Electrical Equipment (Safety) Regulations 2016, Electromagnetic Compatibility Regulations 2016 (SI 2016/1091). The Restriction of the Use of Certain Palmer Pan16 19“ DI-box Hazardous Substances in Electrical and Electronic Equipment Regulation 2012 (SI 2012/),32,) Radio Equipment Regulations 2017 (SI 2016/2015), Adam Hall Ltd. | The Seedbed Bus. Centre | SS3 9QY Essex | UK
Customer Support
- Email: Info@adamhall.com
- Website: www.adamhall.com/compliance
- Ph: +49 (0)6081 / 9419-0
FAQs
Q: What kind of audio signals does it support?
Depending on the wiring, it can handle both mono and stereo balanced audio signals, usually from XLR microphones or line-level sources.
Q: Can it be used for both microphones and line-level instruments?
Indeed. It can handle both higher-level line signals and low-level microphone signals, although it always checks the input level to avoid distortion.
Q: Does it require power?
No, the PAOCBXLRFXLR is a passive device that uses the audio signal to communicate over CAT cable without the need for external power.
Q: Is it compatible with any CAT cable?
It is compatible with CAT5, CAT5e, CAT6, and CAT7 cables.
Q: Can I use it for stage setups or live sound?
Indeed. Long cable runs without signal deterioration make it perfect for live sound, stage setups, and studio settings.
Q: What is the frequency response of the device?
For professional audio applications, the box’s full-range audio architecture ensures transparent signal transmission, usually between 20 Hz and 20 kHz.
Q: Can it handle phantom power for microphones?
No. It does not transmit phantom power because it is passive.