Monater MH22245 Bluetooth Wireless Headphones
Power On/Off
Earphones will turn on when the charging case is opened. To turn off, place the earphones in the charging case, and charging will start when the cover is closed.
Charging Case Wired/Wireless Charging
Besides using the included USB-C charging cable to charge the charging case, the charging case can be charged by a compatible wireless charging device.
Noise Cancellation On/Off
- Press and hold the MFB of the right earphone for 2 seconds to switch between different modes.
- [Noise Cancellation Off] – [Ambient On]-[Noise Cancellation On]
Pairing
- For new device connection, go to Bluetooth settings on your device and search for new devices (new Monster device), “connected” voice prompt will be heard once the earphones are paired.
- When turning on, the earphones will try to connect to the last connected device. To pair a new device, turn off the current connected Bluetooth device.
Connect other devices
Keep the earphones in the charging case and leave the cover open. h Press and hold the Pair / Reset to Factory Settings Button for about 5 seconds until the light indicator starts to flash. It is now in pairing mode. Activate the Bluetooth on your device and set it to search for new devices.
Volume Control
The earphones do not have a volume control function. After Bluetooth connection, volume level can be controlled on theconnected device.
Call
- Answer / End a call: Single-tap the MFB.
- Reject the call: Press and hold the MFB for about 2 seconds.
Music
- Play/Pause music: Single-tap the MFB.
- Previous song: Double-tap the MFB of the left earphone.
- Next song: Double-tap the MFB of the right earphone.
Reset to Factory Settings
Open the cover of the charging case, keeping the left and right earphones inside. Press and hold the Pair/Reset to Factory Settings Button for 10 seconds.
LED Indicator Guide
| Mode | Description | Voice Prompt |
| Power On | – | “Power On” |
| Power Off | – | “Power Off ” |
| Pairing | The white LED indicator of the charging case flashes quickly | “Pairing” |
| Connected | After connecting, the indicator light goes off | “Connected” |
| Earphones charging | When the earphones are charging, the indicator light of the charging case flashes and turns off when it is fully charged.d | – |
| Charging case | During charging, the indicator light of the charging case is on, and the light is off when it is fully charged. | – |
FCC Statement
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Consult the dealer or an experienced radio/TV technician for help
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
IC Caution
Radio Standards Specification RS-Gen, issue 5 – English: This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RS(s). Operation is subject to the following two conditions: This device may not cause interference. This device must accept any interference, including interference that may cause undesired operation of the device.
Customer Service
- Website: support@mct-audio.com