Oster 5964/5965 STAINLESS STEEL ELECTRIC KETTLE Instructions

Oster 5964/5965 STAINLESS STEEL ELECTRIC KETTLE

IMPORTANT SAFEGUARDS

When using electrical appliances, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and/or injury to persons, including the following:

1.  Read all instructions before using the machine.
2.  Do not touch hot surfaces. Use handles or knobs.
3.  To protect against electric shock, do not immerse this appliance, including the power base, in water or any other liquid.
4.  Close adult supervision is necessary when this appliance is used by or near children.
5.  Unplug the power base from the power outlet when not in use, before repositioning, and before cleaning. Allow to cool before putting on or taking off parts, and before cleaning the appliance.
6.  Do not operate any appliance with a damaged cord or plug, or after the appliance malfunctions, or has been damaged in any manner. Return this appliance only to the nearest authorized service center for examination, repair, or adjustment.
7. The use of accessory attachments not recommended by the appliance manufacturer may result in fire, electric shock, or injury to persons.
8. Do not use outdoors.
9. Do not let the cord hang over the edge of the table or counter, or touch hot surfaces.
10. Do not place this appliance on or near a hot gas or electric burner or in a heated oven.
11. Ensure that the kettle is properly located on the power base before plugging it into the wall or switching it on. To disconnect, turn all controls to “Off” and then remove the plug from the wall outlet.
12.  Remove the kettle from the power base before filling or pouring. Do not attempt to remove the kettle from the power base until it is switched off, manually or automatically.
13. Use the kettle only with the power base supplied and vice versa.
14. Do not use the appliance for anything other than its intended use.
15. Use on a hard, flat level surface only, to avoid interruption of air flow underneath the appliance.
16. Extreme caution must be used when handling or moving the kettle and pouring from the kettle containing boiling water.
17. Scalding may occur if the lid is removed during the heating cycle.

SPECIAL CORD SET INSTRUCTIONS

1.  A short power supply cord is provided to reduce the hazards resulting from becoming entangled in or tripping over a longer cord.
2.  An extension cord may be purchased and used if care is exercised in its use.
3. If an extension cord is used, the marked electrical rating of the extension cord must be at least 15 amps and 120 volts. The resulting extended cord must be arranged so that it will not drape over the countertop or tabletop where it can be pulled on by children or tripped over accidentally.

This appliance has a grounded 3-prong electrical plug. It must be plugged only into a properly grounded 3-prong outlet. Do not modify the plug in any way.

PRECAUTIONS

WARNING:

TO AVOID SCALDING, handle this kettle with care as water is heating, boiling, and cooling. The lid must remain in place during use to avoid steam burns.

1. Place the electric kettle well back from the edge of the counter.
2. This kettle is intended for boiling WATER ONLY. Do not heat any other liquid or attempt to cook any food in this appliance.
3. NEVER place the kettle NEAR HOT SURFACES.
4. Hand wash filter only. NO PARTS ARE DISHWASHER SAFE.
5. Do not exceed the “Max” water level mark when filling. Overfilling could cause hot water to boil out of the spout.
6. Do not hold the switch on as this may damage the auto shut-off mechanism.
7. Carry or move the electric kettle by the handle only.
8. The kettle body may get very hot, be careful when handling.
9. Do not immerse the kettle or power base in water or any other liquid.

Diagram of Parts

Clean your electric kettle before first use.

1. Wash the inside of the kettle and lid with mild detergent and water. Rinse each thoroughly. Do not immerse the kettle or power base in water or any other liquid. These items are not dishwasher safe.
2. Fill the electric kettle with fresh water to the “MAX” water level mark. Plug the power base into the power outlet. Place the kettle into the power base. Turn the switch ON by pressing down on the ON/OFF switch. The ON/OFF light will turn on, indicating the kettle is ON. Let the water boil.
3. When the water and unit have cooled, discard the water. Rinse with cold water and repeat.
4. Your electric kettle is now ready for use.

Using your Electric Kettle

1. Position the power base on a flat, heat-resistant surface, as close as possible to a power outlet.
2. Follow the cord routing in the power base according to exit patterns. Proper cord routing will result in the power base lying flat when the kettle is placed in the base. DO not operate the kettle if the power base is not flat. If the power base is not flat, remove the kettle from the power base and repeat the cord placement instructions.
3. To fill with water, remove the lid. Fill the electric kettle with water below the “MAX” water level mark. NOTE: Do not exceed the “MAX” water level mark indicated on the electric kettle.
4. Plug the electric cord into an electric outlet. Turn the switch ON by pushing down on the on/off switch. The on/off light will light up to indicate the unit is on. The water will heat, and the electric kettle will switch off automatically when the water boils. NOTE: Ensure the ON/OFF switch is clear of obstructions and the lid is firmly closed. The electric kettle will not turn off automatically if the ON/ OFF switch is constrained or if the lid is left open.
5. Carefully lift the kettle from the power base and pour the hot water.
6. The kettle will not re-boil until the on/off switch is again switched ON. Wait 25 seconds, allowing the kettle to cool down, then switch ON.

Using Your Kettle’s Keep Warm Feature 

This kettle incorporates a keep-warm function, which maintains the water at a pre-determined temperature after the boiling cycle. The Keep Warm feature is ideal for family breakfasts, commercial breaks, and cooking.

• The Keep Warm function can be switched on before, during, or after boiling. The Keep Warm feature can also be turned off at any time if no longer required.

1. Operate the kettle following the instructions contained in the “Using Your Electric Kettle” section. After filling the kettle and replacing it onto the power base, boil water, then press the Keep Warm button. The Keep Warm button will illuminate when turned on.
2. When activated, the Keep Warm function will maintain the water temperature at approximately 70˚C after boiling. The Keep Warm feature will not boil the water.
3. To turn the Keep Warm feature off, simply press the Keep Warm On/Off button again. The light in the button will turn off, showing that the feature is no longer operating.

NOTE: Never allow the kettle to boil dry or drop below the minimum mark. With the kettle filled to the maximum level (1.5 litres), the kettle can be left with the Keep Warm function on for up to 12 hours.

IF THE KETTLE DOES BOIL DRY

If the kettle is operated in accordance with instructions for use, it is unlikely that the kettle will boil dry. However, if the kettle does boil dry, it is protected bboil-dry dry, fail-safe device which will switch the kettle off automaticalin adry dry situation and keep it switched off until the kettle is refilled with at least the minimum amount of water. Always allow the kettle to cool for half an hour before reuse if the kettle has boiled dry. If the kettle boils dry when the Keep Warm feature is activated, the kettle body will remain warm until switched off and allowed to cool.

Filter instructions

A mesh filter has been integrated into the kettle to reduce the amount of scale residues entering your beverages or food. The filter is removable for cleaning. To reduce scale build-up, empty out any residual water after boiling. How often the filter should be cleaned will vary according to where you live and how often you use your kettle. The filter should be cleaned whenever there are noticeable deposits left on the filter, and especially if the rate of pouring decreases.

Filter removal/cleaning/refitting

Important: The kettle must be switched off, disconnected from the power outlet, and allowed to cool down completely prior to removing or refitting the filter. Do not use excessive force, as this might damage the filter or the lid.

1.  Empty the kettle and lift the lid.
2. Grip the top part of the filter with your index finger and thumb and pull upwards. You may have to hold the kettle while removing the filter. Caution: Keep fingers clear of mesh. Pressing into the mesh may damage the filter.
3. To clean the filter, rinse under a tap while brushing it gently with a soft brush.
4. To refit the filter, once again hold the filter with your index finger and thumb. Gently push the filter back into the kettle until you hear a click. The filter is now reattached. Gently tug on the filter to ensure the filter is attached properly.
5. Rinse out the kettle with fresh water and it’s ready for use.

Care and cleaning of your electric kettle

1. Mineral deposits in tap water may cause scale deposits to form inside the electric kettle after frequent use. To remove this scale build-up, fill the kettle with a solution of 3 cups of white vinegar and 3 cups of water. Let it sit overnight.
2. Empty the vinegar solution from the electric kettle. Remove any stain remaining inside by rubbing with a damp cloth.
3. Fill the electric kettle with clean water. Place the kettle on the power base and bring to a boil, then discard the water. Repeat, and the electric kettle will be ready to use.
4. The electric kettle will not operate again until the on/off switch is pressed downward.
5. Always remove the kettle from the power base and disconnect the power base from the electrical outlet before cleaning. Do not immerse the kettle or power base in water or other liquids.
6. The outside of the electric kettle can be wiped with a soft, damp cloth.

NOTE: Never use any chemical, steel wool, or abrasive cleaners

For product questions, contact:

Jarden Consumer Service
USA: 1 800.334.0759

Canada: 1.800.667.8623

www.oster.ca ©

2013 Sunbeam Products, Inc., doing business as

Jarden Consumer Solutions. All rights reserved.

In the U.S.A., distributed by Sunbeam Products, Inc., doing business as Jarden Consumer Solutions, Boca Raton, FL 33431. In Canada, imported and distributed by Sunbeam Corporation (Canada) Limited, doing business as Jarden Consumer Solutions,

20B Hereford St., Brampton, Ontario L6Y 0M1.

GCDS-OST29382-JC

Printed in China

1-Year Limited Warranty

Sunbeam Products, Inc., doing business as Jarden Consumer Solutions, or if in Canada, Sunbeam Corporation (Canada) Limited doing business as Jarden Consumer Solutions (collectively “JCS”), warrants that for one year from the date of Oster 5964/5965 STAINLESS STEEL ELECTRIC KETTLE purchase, this product will be free from defects in material and workmanship. JCS, at its option, will repair or replace this product or any component of the product found to be defective during the warranty period. Replacement will be made with a new or remanufactured product or component. If the product is no longer available, a replacement may be made with a similar product of equal or greater value. This is your exclusive warranty.

This warranty is valid for the original retail purchaser from the date of initial retail purchase and is not transferable. Keep the original sales receipt. Proof of purchase is required to obtain warranty performance. JCS dealers, service centers, Oster 5964/5965 STAINLESS STEEL ELECTRIC KETTLE or retail stores selling JCS products do not have the right to alter, modify, or in any way change the terms and conditions of this warranty.

This warranty does not cover normal wear of parts or damage resulting from any of the following: negligent use or misuse of the product, use on improper voltage or current, use contrary to the operating instructions, disassembly, repair, or alteration by anyone other than JCS or an authorized JCS service center. Further, the warranty does not cover: Acts of God, such as fire, flood, hurricanes, and tornadoes.

What are the limits on JCS’s Liability?

JCS shall not be liable for any incidental or Oster 5964/5965 STAINLESS STEEL ELECTRIC KETTLE consequential damages caused by the breach of any express, implied, or statutory warranty or condition. Except to the extent prohibited by applicable law, any implied warranty or condition of merchantability or fitness for a particular purpose is limited in duration to the duration of the above warranty. JCS disclaims all other warranties, conditions, or representations, express, implied, statutory, or otherwise.

JCS shall not be liable for any damages of any kind resulting from the purchase, use or misuse of, or inability to use the product including incidental, special, consequential or similar damages or loss of profits, or for any breach of contract, fundamental or otherwise, or for any claim brought against purchaser by any other party. Some provinces, states, or jurisdictions Oster 5964/5965 STAINLESS STEEL ELECTRIC KETTLE do not allow the exclusion or limitation of incidental or consequential damages or limitations on how long an implied warranty lasts, so the above limitations or exclusions may not apply to you. This warranty gives you specific legal rights, and you may also have other rights that vary from province to province, stastateteet, or jurisdiction to jurisdiction.

How To Obtain Warranty Service

In the U.S.A.

If you have any questions regarding this warranty or would like to obtain warranty service, please call 1-800-34-  and a convenient service center address will be provided to you.

In Canada

If you have any questions regarding this warranty or would like to obtain warranty service, please call 1 800-667-8623, and a convenient service center address will be provided to you.

In the U.S.A., this warranty is offered by Sunbeam Products, Inc., doing business as Jarden Consumer Solutions, located in Boca Raton, Florida 33431. In Canada, this warranty is offered by Sunbeam Corporation (Canada) Limited, doing business as Jarden Consumer Solutions, located at 20B Hereford Street, Brampton, Ontario L6Y 0M1.

FAQs

What is the capacity of the kettle?

The minimum suggested fill is 0.5 litres, while the maximum water volume is 1.7 litres. While underfilling could activate the boil-dry safety mechanism, overfilling could result in boiling water spilling.

How does the automatic shut-off work?

A thermostat sensor built inside the kettle senses when the water reaches a rolling boil. In order to avoid boiling over or overheating, it will turn off automatically.

What is boil-dry protection and why is it important?

With boil-dry protection, the kettle won’t run without water. To prevent harming the heating element, the mechanism will automatically turn off the kettle if it is turned on without any water in it.

Can I use the kettle to heat liquids other than water?

No. This kettle is only meant to be used with water. Boiling other liquids, such as milk or oil, could harm the kettle or pose a risk to public safety.

Is the kettle cordless?

Indeed. The kettle is cordless in and of itself. It can be easily lifted, poured, and replaced without unplugging thanks to its 360° rotating base. The power supply is still linked to the base.

Why is there steam coming from the lid?

Normal steam is a sign that the water has boiled or is almost boiling. When opening or pouring, always use caution to prevent burns.

Can I leave the kettle plugged in after boiling?

Indeed. The automatic shut-off ensures that the kettle stays off after boiling. For extra security, it is advised to disconnect it when not in use.