Hama 00222205 KOS White Alarm Clock
Safety instructions
- The product is intended for private, noncommercial use only.
- Do not operate the product outside the power limits given in the specifications.
- Do not use the product in a damp environment and avoid splashing water.
- Do not drop the product, and do not expose it to any major shocks.
- Dispose of packaging material immediately according to the locally applicable regulations.
- Do not modify the product in any way. Doing so voids the warranty.
- Protect the product from dirt, moisture, and overheating, and use it in dry environments only.
- Do not use the product near heaters, other heat sources, or in direct sunlight.
- Do not use the product in areas where electronic products are not permitted.
- Keep the packaging material out of the reach of children due to the risk of suffocation.
- Do not open the device or continue to operate it if it becomes damaged.
- Do not attempt to service or repair the Hama 00222205 KOS White Alarm Clock the product yourself. Leave any service work to qualified experts.
- As with all electrical products, this device should be kept out of the reach of children.
- Only use the article under moderate climatic conditions.
Batteries/Button Cells
- When inserting batteries, note the correct polarity (+ and – markings) and insert the batteries accordingly. Failure to do so could result in the batteries leaking or exploding.
- Only use batteries that match the specified type. Keep the instructions for the correct choice of batteries included with the operating instructions of devices, for safe future reference.
- Before you insert the batteries, clean the battery contacts and the polarity contacts.
- Do not allow children to change batteries without supervision.
- Replace all the batteries in a set at the same time.
- Do not mix old and new batteries, or batteries of different types or from different manufacturers.
- Remove the batteries from products that are not being used for an extended period (unless these are being kept ready for an emergency).
- Keep new and used button cells out of the reach of children.
Inserting/changing the batteries
- Open the battery compartment and remove the contact breaker.
- Then close the battery compartment.
- When changing the battery, remove and dispose of the spent battery and insert a new CR2032 button cell, observing the correct polarity.
Operation
Manual setting of the time and date
- Press and hold the SET button for around 2 seconds to go to Setting mode. Set the following information in sequence: year, day/month or month/day, month, day, hour, minute.
- To select the individual values, press the Up or Down button and confirm the selection by pressing the SET button.
Controls and displays
- Up button = Increase the setting value
- Down button = Decrease setting value, toggle C°/F°
- SET button = Setting mode, confirmation
Alarm clock
- Briefly press the SET button to switch to Alarm mode. „AL“ appears in the display. Press and hold the SET button for around 2 seconds to go to Setting mode.
- The alarm time starts to flash. To select the Individual values, press the UP or DOWN button, and confirm your selection by pressing the SET button.
- During the alarm signal, press any button apart from the Snooze button to stop the alarm.
- If the alarm clock is triggered, an alarm signal sounds for 2 minutes. The frequency of the alarm signal increases as the duration of the alarm increases.
- Press any button other than the Snooze button to stop the alarm.
Technical Data
- Power supply 1x CR2032
Care and Maintenance
- Only clean this product using a lint-free, slightly damp cloth, and do not use any harsh cleaners.
- Ensure that no water is able to enter the product.
Warranty disclaimer
Hama GmbH & Co KG assumes no liability and provides no warranty for damage resulting from improper installation, mounting, and improper use of the product or failure to observe the operating instructions and/or the safety instructions.
Customer Support
- Website: https://uk.hama.com
- Tel: +49 9091 502-2
FAQs
Q: How do I set the time on the Hama KOS White Alarm Clock?
Holding down the “MODE” button until the hour numbers start to flash will set the time. Use the “UP” or “DOWN” buttons to change the hour, and then press “MODE” once more to go to the minutes.
Q: How do I set or change the alarm time?
To activate alarm mode, press the “ALARM” button. Hold “ALARM” until the alarm hour begins to flash, then adjust the desired alarm time by pressing “UP” and “DOWN.” To be sure, press “ALARM” once more.
Q: Does the Hama 00222205 KOS Clock have a snooze function?
Indeed. Press the “SNOOZE/LIGHT” button to pause the alarm for about five minutes when it goes off. After the snooze period, the alarm will automatically start up again.
Q: How can I switch between 12-hour and 24-hour display formats?
Press and hold the “UP” button until the time format shifts from 12 to 24 hours.
Q: Is the display backlit for nighttime viewing?
Yes, there is a gentle white glow on the Hama KOS White Alarm Clock. To make the display easier to read in the dark, use the “SNOOZE/LIGHT” button to temporarily illuminate it.
Q: How do I replace the batteries?
Lift the lid off the clock’s battery compartment. Make sure you use the proper polarity (+/-) when inserting two AAA (1.5V) batteries. If necessary, replace the cover and reset the alarm and time.
Q: My clock is not working, or the display is blank. What should I do?
To reset the gadget, take out the batteries for five to ten minutes and then put them back in if the problem continues.
