Russell Hobbs 25600-56 Handheld Garment Steamer User Guide

Russell Hobbs 25600-56 Handheld Garment Steamer

Safety Instructions

This appliance can be used by children aged 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been supervised/instructed and understand the hazards involved. Children shall not play with the appliance. Children shall not do cleaning and user maintenance unless they are older than 8 and supervised. Use and store the appliance out of reach of children under 8 years.  Between uses, the steamer must be rested on a stable, level, heat-resistant surface. Don’t leave the appliance unattended while plugged in, or while it’s resting between uses.

1. Unplug the appliance before filling, before cleaning, and after use.
2. Don’t operate the appliance if it’s dropped or damaged, or if it malfunctions or leaks.
3. If the cable is damaged, return the appliance to avoid a hazard.
4. The surfaces of the appliance will get hot during use.
5. Do not use this appliance near bathtubs, showers, basins or other vessels containing water.
6. Never use anything except water to fill or clean the appliance.
7. Never steam clothing that is being worn.
8. Never aim steam directly at people, animals or plants.
9. Steam is hot and can cause serious burns and scalds if used without care.
10. Never hold the steam head downwards while at rest, or tilt it backwards, as this may cause hot water to be discharged and possible injury.
11. Ensure the appliance is switched off and cooled down before fitting or removing attachments.
12. Don’t use the appliance for any purpose other than those described in these instructions.

Parts

1. Steam trigger lock
2. Steam trigger
3. Handle
4. Water tank
5. Power button
6. Lint attachment
7. Delicate fabric attachment
8. Upholstery attachment

Before First Use

• Remove labels, stickers and packaging from the appliance.
• For best performance, we recommend using distilled, purified or filtered water in your steamer.
• Tap water contains minerals that can build up inside your steamer over time and reduce its efficiency or even cause damage.
• Never use perfumes, oils or other additives.
• During use, the steamer and accessories will become HOT.
• Never try to fit or remove attachments while still hot.
• After preheating, prime the water pump by holding the steam trigger until steam forms.
• It is normal to feel or hear the water pump inside the device.
• It may become louder when the water level in the tank is low.
• Check and refill the tank when required.
• Small amounts of dripping might occur during use.
• If excessive, your steamer needs time to get back up to full temperature.
• Just allow the steamer a minute to reheat.
• Wearing clothes immediately after ironing or steaming can create wrinkles.
• Always allow the clothing to cool for about 5 minutes before wearing.

Attachments

Your steamer has three attachments:

• Lint attachment: Use on garments labelled k l that allow the use of steam.
• Tip: The pad on the attachment helps remove lint, hair, and animal fur.
• Delicate fabric attachment. Use on garments labelled that allow the use of steam.
• Tip: For items with printing/embellishment, turn the garment inside out to avoid damage to sensitive areas.
• Upholstery attachment: Use to sanitize and refresh bedding, mattresses, curtains, plush toys, furniture, and hard surfaces (such as worktops or desks that are not heat sensitive). Always test for colourfastness and heat sensitivity on an inconspicuous area.

Fitting/Removing

1. Make sure that the steamer and attachment are cool.
2. Hook the top of the attachment over the top edge of the steamer.
3. Click the bottom edge into place.
4. Remove the attachment using the tab.
5. When removing the attachment, watch out for condensation that may have built up during use.

Filling

1. Place the steamer on its base on a stable surface.
2. Pull out the removable water tank.
3. Gently open the rubber cover at the top of the tank.
4. Fill until the water reaches the “MAX” level mark on the top of the tank. Do not overfill.
5. Close the rubber cover securely.
6. Dry off any excess water from Russell Hobbs 25600-56 Handheld Garment Steamer the tank, then refit it into the base until it clicks.

• To refill at any time during use, turn the steamer off by pressing the power button until the blue indicator light goes out, unplug from the outlet, and follow the above procedure.
• After refilling, allow to reheat for 45 seconds and then prime the pump by holding the steam trigger until steam forms.

Using the Appliance

1. If the label says “do not iron” or shows this icon, fit the delicate attachment and make sure to test on an inconspicuous area before steaming the entire garment.
2. If the label says “do not steam” or shows this icon, do not steam the garment.
3. Fit any attachment you wish to use.
4. Plug the steamer in, then press the power button. The blue power button light will slowly flash, indicating that the steamer is heating.
5. After about 45 seconds, the power light will stay on, indicating the steamer is preheated.
6. Prime the water pump by holding the steam trigger until steam forms.
7. To generate steam, press the steam trigger.
8. As long as the trigger is held, steam will be emitted from the steamer.
9. When the trigger is released, the steam will stop.
10. You can then release pressure on the steam trigger.
11. To turn the steam off, press the trigger. Russell Hobbs 25600-56 Handheld Garment Steamer slide the steam trigger lock upwards, then release the trigger.
12. With your free hand, keep the fabric taut. Steam the garment with slow, downward strokes, keeping the head of the steamer in contact with the fabric.
13. When you have finished, press and hold the power button until the blue light goes out (about 3 seconds) and unplug.
14. Stand the steamer on its base and allow it to completely cool off before storing.
15. To avoid mineral buildup, empty the tank after each use.

Auto Shut Off

Your steamer will automatically switch to auto shut-off mode after being left inactive for 15 minutes. The
power button light will flash rapidly to indicate this. To resume steaming, press the steam trigger or power button and wait for your steamer to fully reheat.

Care & Maintainance

1. Make sure the teamer is off, unplugged and completely cool.
2. Wipe all surfaces with a clean, damp cloth.
3. After the steamer has been thoroughly dried, turn it back on and lightly steam over an old cloth.
4. This will help remove any residue left in the steam holes.
5. To avoid mineral buildup, empty the tank after each use.

Cleaning Attachments

• Lint attachment: Wipe with an amp cloth to clean.
• Delicate fabric attachment: Wash with cold water and small amounts of a gentle cleanser if needed. The fabric cannot be removed.
• Upholstery attachment: The fabric can be removed and hand-washed with cold water and a gentle cleanser.

Troubleshooting

Recycling

To avoid environmental and health problems due to hazardous substances, appliances, and rechargeable and non-rechargeable batteries marked with one of these symbols must not be disposed of with unsorted municipal waste. Always dispose of electrical and electronic products and, where applicable, rechargeable and non-rechargeable batteries at an appropriate official recycling/collection point.

Warranty Information

(Applies only in the United States and Canada) For service, repair, or any questions regarding your appliance, please call our Customer Service. Please DO NOT return the product to the place of purchase. Also, please DO NOT mail the product back to the manufacturer, nor bring it to a service center.

What does it cover?

Any defect in material or workmanship provided; however, the liability of Spectrum Brands, Inc. will not exceed the purchase price of the product.

How long is the warranty valid?

• In the United States: Two years from the date of original purchase with proof of such purchase.
• In Canada: Two years from the date of original purchase with proof of such purchase.

What will we do to help you?

• Provide you with a reasonably similar replacement product that is either new or factory refurbished.

How do you get service?

• Save your receipt as proof of the date of sale.

What does your warranty not cover?

• Damage from commercial use
• Damage from misuse, abuse, or neglect
• Shipping and handling costs associated with the replacement of the unit
• Consequential or incidental damages (Please note, however, that some states do not allow the exclusion or limitation of consequential or incidental damages, so this limitation may not apply to you.)

How does state law relate to this warranty?

• This warranty gives you specific legal rights.
• You may also have other rights that vary from state to state or province to province.

Customer Service

• Website: www.prodprotect.com/russellhobbs
• Tel: 1-800-947-3744