Rowenta SO 9260 Mechanic Ceramic Fan Heater
Safety Instruction
- Read all instructions before using this heater.
- Always unplug the heater when not in use.
- Discard heater, or return to authorized service facility for examination and/or repair.
- This heater is not intended for use in bathrooms, laundry areas, or similar indoor locations.
- Never locate the heater where it may fall into a bathtub or other water container.
- Do not run cord under carpeting.
- Do not cover the cord with throw rugs, runners, or similar coverings.
- Do not route the cord under furniture or appliances.
- Arrange the cord away from tra=c area and where it will not be tripped over.
- To disconnect the heater, turn the controls to off>, then remove the plug from the outlet.
- To prevent a possible #re, do not block air intakes or exhaust in any manner.
- Do not use on soft surfaces, like a bed, where openings may become blocked.
- A heater has hot and arcing, or sparking parts inside.
- Do not use it in areas where gasoline, paint, or ammable liquids are used or stored.
- Use this heater only as described in this manual.
- Always plug heaters directly into a wall outlet/ receptacle.
- Never use with an extension cord or relocatable power tap (outlet/power strip).
- When unplugging, be sure to pull by the plug and not the cord.
- Before use, always check that the appliance, plug, and power cord are in good condition.
- The heater must not be located immediately below a socket outlet.
- Never allow water to get into the appliance.
- Do not touch the appliance with wet hands.
Features
- Control panel
- Carrying handle
- Air outlet screen
- Air inlet screen (with #lter)
Plug the switch
Drying
Fan
Heating
Warning
Before First Use
- The air intake and outlet grills are completely unobstructed.
- The appliance must be installed so that the mains power socket is accessible.
- Do not pull on the power cord or the appliance, even when unplugging it from a wall socket.
- Never use the appliance in an inclined or horizontal position.
- Always unroll the power cord completely before use.
- Do not use an extension cable that is not adapted to the voltage of your appliance.
- Do not use the appliance in a dusty room or a location where there is a risk of #re.
- Switch off> the appliance and unplug it before cleaning or storing it.
Maintainance
Always be sure the heater is switched OFF, unplugged, and completely cooled before cleaning or attempting to store the item. The Heater takes approximately 15-20 minutes to cool completely. Do NOT immerse the heater in water or allow water to drip into the interior of the heater, as this could create an electric shock hazard.
Regardless of the type of heating system setup, always install and maintain at least one smoke detector in good working condition on each floor of your home. Periodically check and/or replace the battery in your smoke detector with a fresh battery.
Cleaning & Storage
- Always turn> the heater and disconnect the cord from the electrical outlet before cleaning your heater.
- Light accumulated dust may be removed from the heater with a soft cloth or vacuum cleaner.
- Clean the outside of the heater by wiping with a damp cloth and bu> with a dry cloth.
- DO NOT use any detergents or abrasives, and do not allow any water to enter the heater.
- DO NOT allow water to run into the interior of the heater, as this could create a fire or an electric shock hazard.
Troubleshooting
- A safety device shuts down the unit. Unplug your device and allow it Rowenta SO 9260 Mechanic Ceramic Fan Heater to cool down at least 30 minutes; then eliminate the fault that might have locked your device.
- Once cool, plug back into the electrical outlet for use.
- Do not disassemble the appliance yourself. A poorly repaired appliance may be dangerous for the user.
- Do not use the appliance and contact Rowenta SO 9260 Mechanic Ceramic Fan Heater an Approved Service Centre if :
Customer Service
- Website: https://www.rowenta.ca/
- Mailing address: 36 Newmill Gate, Unit 2, Toronto, ON, Canada M1V 0E2
- Phone number: 1-800-418-3325
- Hours of service: Monday to Friday, 8:30 to 5 pm EST
FAQs
Q: How does the Rowenta SO 9260 heater work?
The heater swiftly warms the air in a space by combining ceramic heating components with a fan. Ceramic components use less energy and heat up quickly while providing steady warmth.
Q: What safety features are included?
If the internal temperature rises too high, the heater’s overheat prevention feature will immediately turn it off.
Q: Can I use the fan-only mode?
Indeed, during warmer months, the fan-only option provides ventilation or a little cooling by moving air around without heating.
Q: How far should I keep the heater from walls and objects?
Make sure that walls, furniture, curtains, and other combustible objects are at least three feet (1 metre) away. This lowers the risk of fire and avoids overheating.
Q: Is it safe to use in bathrooms or damp areas?
No, dry inside environments are the unit’s intended use. Moisture exposure poses a major safety risk and can harm electrical components.
Q: How do I clean the heater?
Make sure the device is fully cooled and disconnected. Use a gentle, dry towel to clean the outside. Avoid using harsh cleansers or submerging in water. Don’t put anything in the air vents.
Q: Why is my heater not producing heat?
Verify that the thermostat is set above the room temperature and that the device is hooked in and turned on. It might be necessary to turn the heater upright in order to reset the tip-over switch if it had tipped over.