Russell Hobbs RHK26330 Quiet Kettle
Safety Instructions
When using electrical appliances, basic safety precautions should always be followed, including:
- To protect against electrical hazards, do not immerse the power cord, plug, power base, or kettle in
water or any other liquid. - Always use the appliance’s handles, as some parts may be hot.
- Always turn off and unplug from the power outlet before cleaning the appliance.
- Turn the power off at the wall power outlet when not in use.
- To disconnect, turn off the wall power outlet, then grasp and pull the plug from the wall outlet.
- Never pull by the cord. There are no user-serviceable parts.
- Do not use on an inclined plane or unstable surface.
- Do not move the kettle while it is switched on.
- Ensure the lid is properly closed, or the kettle may not switch off once boiled.
- Do not open the lid while the water is boiling.
- Always take care when pouring. Pour slowly, do not over-tilt the kettle.
- Only use the kettle with the power base provided and vice versa.
- Wind excess cable beneath the power base. Do not place on or near any heat sources.
- Do not use this appliance for anything other than its intended purpose of heating water.
- Do not switch on the kettle unless there is at least one cup of water. Misuse may cause injury.
- Do not fill past ‘max’, otherwise boiling water may be ejected from the spout.
- Do not use without a filter fitted. Do not fill through the spout.
- Do not use alkaline cleaning agents or harsh abrasives when cleaning this appliance.
- Follow the instructions in the ‘Care and Maintenance’ section when cleaning this appliance.
- Descalcify the kettle regularly to ensure proper operation.
Parts
- Filter
- Lid
- Lid release button
- Water level gauge
- Switch
- Stand
- Light
Before First Use
Fill the kettle with water to the MAX level mark on the water gauge. Boil, discard the water, and then rinse to remove any dust, residues, etc., from the kettle. Repeat as required.
- Ensure the filter is in place; otherwise, the kettle may not switch off and may spit water from the spout.
Positioning
- Place the base on a stable, level surface.
- Route the cable so it does not overhang and cannot be caught or tripped over.
- Wind excess cable beneath the base.
- Position your kettle to ensure the spout directs steam away from curtains, drapes, and overhead cupboards.
Filling
If the kettle has just boiled, it will be full of steam. Keep your hands clear as steam will escape from the kettle when opening the lid.
- Remove the kettle from the power base.
- Open the lid. Fill the kettle to at least the MIN level mark on the water gauge.
- Do not fill above the MAX level mark. If overfilled, boiling water may be ejected from the spout.
- Close the lid. Check that the lid is fully closed, or the kettle may not switch off when it boils.
Switching On/Off
Keep clear, as steam will escape from the spout when boiling.
- Plug the power cord into the wall power outlet and switch it on.
- Place the kettle on the power base – take care not to spill any water.
- Move the switch to I.
- The light will come on. The kettle will start to heat.
- When the water boils, the kettle will switch itself off.
- To switch off manually, move the switch to O, or simply lift the kettle off the stand
General
- Remove the kettle from the power base before pouring.
- To avoid the risk of splashing, pour slowly and do not over-tilt the kettle.
- Do not tilt the kettle backwards as water might get into the control area.
- If this happens, empty any remaining water and allow the kettle to dry before further use.
- It is somewhere warm for 12 hours.
- When you lift the kettle, you may see moisture on the power base. This is the steam used to switch the kettle off automatically, which then condenses and escapes via vents under the kettle. This is normal.
Insufficient Water
- Using the kettle with insufficient water will shorten the life of the element.
- If the kettle is accidentally switched on when it does not contain sufficient water, a boil-dry cut-out will switch the kettle off.
- Remove the kettle from the power base, and the boil switch will pop up.
- Set the kettle on a stable heat-resistant surface until it has fully cooled down.
- Do not fill the kettle with water until it is cold, or it may spit.
Care & Maintainance
- Switch the power off and remove the plug from the wall power outlet.
- Allow the kettle to cool down fully.
- Wipe over the outside of the kettle and power base with a damp cloth.
- A mild dishwashing detergent may be used if required.
- Keep all connectors and sockets dry.
- Do not immerse the kettle or power base in liquid.
- Do not use alkaline cleaning agents or harsh abrasives when cleaning this appliance.
- Clean the inside of the kettle using the instructions in the “DE-SCALE REGULARLY” section.
Quiet Boil
This Russell Hobbs kettle reduces the noise emitted while boiling. As you use the kettle, scale will deposit on the base of the kettle, slowly decreasing the effect of noise reduction. Regular descaling will keep your kettle clean and quiet.
Desclaing
Water contains minerals that will form deposits on the inside of your kettle, commonly referred to as scaling. Scaling discolours the internal surfaces and can affect the heating and noise performance. To maintain the performance of your kettle, it should be descaled every three months or so. Descaling more frequently if you live in a hard water area.
- Add a commercially available descaler to the empty kettle according toe, by the instructions on the descaler packaging (Available from your supermarket).
- Fill the kettle with fresh cold water to the MAX level mark on the water gauge.
- Switch the ON/OFF switch to ON and allow the kettle to boil.
- Once the water has boiled, allow the kettle to cool.
- Once the kettle has cooled, pour the water into the sink.
- Fill the kettle with fresh cold water to the MAX level mark on the water gauge.
- Switch the ON/OFF switch to ON and allow the kettle to boil.
- Discard the water into the sink.
- Rinse 1 or 2 times further with fresh water as required.
Water Filter
Scale particles suspended in the water may give it a cloudy or greasy appearance. The filter will prevent these particles from going into your drink. Remove and clean the filter regularly.
Cleaning
- Check that your hands are free from soap, hand cream, or anything that might leave a taint.
- Switch the power off and remove the plug from the wall power outlet.
- Allow the kettle to cool down fully.
- Open the lid.
- Pull the filter up and out of its housing.
- Take care not to press on the mesh part of the filter – you may damage it.
- Rinse the filter under a running tap whilst brushing with a soft brush.
- Rinse the kettle in case scale particles have fallen inside.
- Turn the filter so the tab at the top of the filter faces the rear of the kettle.
- Slide it down into the guides in the filter housing. Ensure it is firmly in place.
- Refill the kettle and close the lid.
Disposal/Recycling
Legislation in some localities mandates that e-waste (anything with a plug, battery, or cord) be disposed of through controlled recycling facilities and must not be disposed of in general household waste. For more information about the recycling of electrical and battery-operated appliances, please contact your local council or your local household waste disposal service. Service. Spectrum Brands Australia Pty Ltd and Spectrum Brands New Zealand Ltd Warranty Against Defects
Warranty Information
(Applies only in the United States and Canada) For service, repair, or any questions regarding your appliance, please call our Customer Service. Please DO NOT return the product to the place of purchase. Also, please DO NOT mail the product back to the manufacturer, nor bring it to a service centre.
What does it cover?
Any defect in material or workmanship provided; however, the liability of Spectrum Brands, Inc. will not exceed the purchase price of the product.
How long is the warranty valid?
- In the United States: Two years from the date of original purchase with proof of such purchase.
- In Canada: Two years from the date of original purchase with proof of such purchase.
What will we do to help you?
- Provide you with a reasonably similar replacement product that is either new or factory refurbished.
How do you get service?
- Save your receipt as proof of the date of sale.
What does your warranty not cover?
- Damage from commercial use
- Damage from misuse, abuse, or neglect
- Shipping and handling costs associated with the replacement of the unit
- Consequential or incidental damages (Please note, however, that some states do not allow the exclusion or limitation of consequential or incidental damages, so this limitation may not apply to you.)
How does state law relate to this warranty?
- This warranty gives you specific legal rights.
- You may also have other rights that vary from state to state or province to province.
Customer Service
-
- Website: www.prodprotect.com/russellhobbs
- Tel: 1-800-947-3744
FAQs
Q: What makes the RHK26330 a “quiet” kettle?
This kettle is perfect for early mornings or shared living areas because of its quiet-boil technology, which greatly minimises the usual boiling noise without compromising performance.
Q: What is the water capacity?
With a maximum capacity of 1.7 litres, the kettle can make about 6-7 normal cups of tea or coffee.
Q: What is the power rating?
The RHK26330 boils quickly and effectively while running quietly at 2200–2400 watts.
Q: Does it have an automatic shut-off feature?
Yes, when the water reaches a boiling point, the kettle turns off on its own. Additionally, it includes boil-dry protection, which prevents it from working in the absence of water.
Q: Is the kettle cordless?
Yes, you can effortlessly lift and reposition the kettle from any angle thanks to its 360-degree swivel base.
Q: Can I leave the kettle on the base all the time?
Yes, when not in use, the kettle can stay on its base. However, to avoid limescale accumulation, do not leave water inside for extended periods of time.
Q: What kind of materials are used in this kettle?
Stainless steel and BPA-free plastic are used in the construction of the RHK26330, guaranteeing longevity, security, and a contemporary look.
Q: Why is my kettle making noise despite being “quiet”?
Every kettle makes some noise when it boils. Even though the “quiet” mode lessens the loud whistle and bubbling, you might still hear faint boiling sounds, particularly when there is a lot of water.