Shark IR70 Cord-Free Ultra-Light Vacuum
Reach Anywhere
Press the MultiFLEX® Lock Release button to lower the angle of the wand to increase your reach.
Store Anywhere
Press the MultiFLEX Lock Release button and fold the handheld vacuum forward. To vacuum, lift the handheld vacuum until the wand locks in place.
Emptying the Dust Cup
- To empty the dust cup, first disconnect the handheld vacuum from the wand by pressing the Wand Release button and pulling up on the handheld vacuum.
- Position the dust cup over a trash bin and slide the lid release button forward.
What’s Inside
- A Handheld Vacuum
- B DuoClean PowerFins Floor Nozzle
- C MultiFLEX Wand
- D Crevice Tool
- E Dusting Brush
- F Anti-Allergen Brush
- G Charger
- H HEPA Post-Motor Filter (Pre-Installed)
Power Settings
OFF
Slide the switch to the top to turn off the power. To begin vacuuming in Standard Mode, slide the switch to the appropriate setting.
Bare Floor Setting
Bare Floor/Area Rugs: Slide the switch to the middle. The brushroll spins slowly to clean bare floors and small area rugs.
Carpet Slide switch to the bottom. The brushroll spins faster to pick up debris below the surface of your carpets.
Boost Mode
For an added boost in power, pull the Trigger on the handheld vacuum. Release it to return to standard power.
For deep cleaning per ASTM F 608 (embedded Shark IZ1441H PowerFins Cordless Vacuum dirt in carpets), please select the Carpet setting and pull the trigger to go into Boost mode.
LI-Ion Battery
In Use
Full charge takes approximately 3 hours.
Battery Indicator Lights
The battery comes partially charged. Charge fully before first use.
Charging
- To charge, remove the handheld vacuum from the wand by pressing the Wand Release button and pulling up. Plug the charger into the charging port.
- To put the vacuum in storage mode, press the MultiFLEX Lock Release button while folding the handheld vacuum forward until the wand clicks and locks. Plug the charger into the charging port on the battery.
Battery Runtime
Customer Support
- Website: sharkclean.com
- Ph: 0800 368 7155
FAQs
Q: What is the Shark IR70?
The Shark IR70 is an incredibly lightweight, cordless stick vacuum made for regular cleaning. It has cordless convenience, multi-surface cleaning for low-pile carpets and hard floors, and PowerFins brush roll technology.
Q: What is PowerFins brush roll technology?
The IR70’s gentle, motorised brush roll with fins removes debris from carpets and hard surfaces without tangling hair. It lowers maintenance and increases pickup efficiency.
Q: Can I use it on multiple floor types?
Indeed. The Shark IR70 may be used on stairs, rugs, low-pile carpets, and hard floors. For carpets or thicker rugs, use Max Mode.
Q: Can I vacuum pet hair?
Indeed. The PowerFins brush roll is perfect for collecting pet hair on hard surfaces and carpets because of its lightweight construction. For high shedding, frequent brush and dust cup cleaning is advised.
Q: Can I vacuum stairs with the IR70?
Indeed. For stairs, use the hand mode to ensure a secure grasp and safe operation.
Q: Can the vacuum handle wet spills?
No, the IR70 is exclusively intended for dry debris. Steer clear of liquids to avoid damaging your motor.
Q: Does the IR70 have a warranty?
Indeed. A two-year limited warranty covering material and workmanship defects is included with the Shark IR70. Visit Shark Support to register your product.
Q: Can I use third-party filters or attachments?
To preserve suction effectiveness, safety, and warranty coverage, it is advised to utilise Shark-approved parts.