Black And Decker HSM13E1 Steam Mop Instructions Guide

Black And Decker HSM13E1 Steam Mop

Safety Instructions

When using your appliance, basic precautions should always  be followed, including the following:

1. Read all instructions.
2. To reduce the risk of contact with hot water emitting from steam vents, check the appliance before each use by holding it away from the body and the rating steam button.
3. Use the appliance only for its intended use.
4. To reduce the risk of electric shock, do not immerse the appliance in water or other liquids.
5. Never yank the cord to disconnect from the outlet; instead, grasp the plug and pull to disconnect.
6. Do not allow the cord to touch hot surfaces. Let et appliance cool completely before putting it away.
7. Loothe p cord loosely arouthe nd appliance when storing.
8. Do not operate the appliance with a damaged cord, or if the appliance has been dropped or damaged.
9. Close supervision is necessary for any appliance being used by or near children.
10. Do not leave the eave appliance unattended while connected.
11. Burns could occur from touching hot metal parts, hot water, or steam.
12. Use care when you turn a steam appliance upside down – there may be hot water in the reservoir.

Polarized Plug

To reduce the risk of electric shock, this equipment has a polarized plug (one blade is wider than the other). This equipment must be used with a suitable polarized 2-wire or 3-wire extension cord. Polarized connections will fit together only one way. Make sure that the receptacle end of the extension cord has large and small blade slot widths. Do not change the tool plug or extension cord in any way.

Minimum Gauge for Cord Sets

• Read all of this manual carefully before using the appliance.
• The intended use is described in this manual.
• The use of any accessory or attachment or the performance of any operation with this appliance other than those recommended in this instruction manual may present a risk of personal injury.
• Retain this manual for future reference.

Description

1. On/off switch
2. Steam button
3. Water tank access tab
4. Water tank
5. Steam head connector
6. Steam head
7. Microfiber cleaning pad
8. Handle the connector button
9. Handle tube
10. Cord hook
11. Grip
12. Power cord

Using the Appliance

• Do not direct steam at people, animals, electrical appliances, or electrical outlets.
• Do not be exposed to rain. Do not immerse the appliance in water.
• Do not leave the appliance unattended. Keep children away from the unit while in use.
• Do not leave the appliance connected to an electrical outlet when not in use.
• Never pull the power cord to disconnect the appliance from the socket.
• Keep the appliance cord away from heat, oil, and sharp edges.
• Do not handle the steam cleaner with wet hands.
• Do not use it on any unsealed hard surfaces or painted surfaces.
• It is always recommended to test an isolated area of the surface to be cleaned before proceeding.
• We also recommend that you check the use and care instructions from the floor manufacturer.
• The appliance emits very hot steam to clean the area of use.
• This means that the steam floor head and cleaning pads get very hot during use.
• Steam may escape from the appliance during use.
• Care should be taken when using this appliance.
• DO NOT touch any parts that may become hot during use.

After Use

• Unplug the appliance and allow it to cool.
• When not in use, the appliance should be stored in a dry place.
• Children should not have access to stored appliances.

Insprction & Repairs

• Unplug the appliance and allow it to cool down before performing any maintenance or repairs.
• Before use, check the appliance for damaged or defective parts. Check for breakage of parts, damage to switches, and any other conditions that may affect its operation.
• Regularly check the power cord for damage.
• Do not use the appliance if any part is damaged or defective.
• Have any damaged or defective parts been repaired or replaced by an authorized repair agent?
• Never attempt to remove or replace any parts other than those specified in this manual.

Intended Use

Your BLACK+DECKER HSM13E1 steam mop has been designed for cleaning the following SEALED floors: hardwood, laminate, linoleum, vinyl, ceramic tile, stone, and marble floors. This appliance is intended for indoor household use only.

Assembly

Do not attempt to modify or repair the appliance. Before attempting any of the following operations, make sure that the appliance is switched off and unplugged and that the appliance is cold and contains minimal or no water.

Attaching the Handle

Slide the bottom end of the handle tube 9 into the top end of the steam mop body until it is firmly seated, and the handle connector button 8 clicks into place.

Attaching the Steam Head

Connect the steam mop body to the steam head 6 via the steam head connector 5, ensuring the connection button 13 clicks into place in the opening 14.

Attaching a Cleaning Pad

Replacement cleaning pads are available from your BLACK+DECKER dealer (cat. no. SMP20).

• Place a microfiber cleaning pad 7 on the floor with the ‘loop’ side facing up.
• Press the steam mop down onto the cleaning pad. You are now ready to steam clean your floor.

Removing a Cleaning Pad

1. Return the handle tube 9 to the upright position and turn the steam mop ‘OFF’.
2. Wait until the steam Black And Decker HSM13E1 Steam Mop cools down (approximately 5 minutes).
3. With suitable shoes on, step on the edge of the cleaning pad and lift the steam mop away from the cleaning pad, freeing it from the ‘hook & loop’ fastening.

Filling the Water Tank

1. Make sure the steam mop is turned off and unplugged.
2. Open the water tank access tab 3.
3. Fill the water tank 4 with water.
4. Replace the water tank access tab.

Operation

Switching On and Off

1. To switch the appliance on, press the On/Off button 1.
2. Press the steam operation button 2.
3. This will operate the pump, and the unit will begin to produce steam.
4. To stop steam generation, turn the steam operation button 2 to Off.
5. This will maintain power to the boiler for quicker startup.
6. To switch the appliance off, press the On/Off button 1.

Optimum Use

• Before use, always prepare the work surface by vacuuming or sweeping up any loose dirt or debris.
• Do not use chemical cleaners with your steam system.
• Allow the steam mop 30 seconds to reach full temperature if starting from cold.
• To clean the surface, tilt the steam mop handle at a 45‑degree angle, make direct contact of the microfiber pad to the floor or work surface, and push the mop slowly on a small area at a time, making 5 swiping (back and forth) passes. Allow the area to air dry before resuming use.
• When used according to the above directions, this mop, with the use of the microfiber pad, kills 99.9% of germs*.

Steam Cleaning

1. Place a cleaning pad 7 on the floor with the ‘loop’ side facing up.
2. Lightly press the steam mop down onto the cleaning pad 7
3. Plug the steam mop into a wall outlet.
4. Press the ON/OFF button 1.
5. It takes approximately 15‑30 seconds for the steam mop to heat up.
6. Press the steam operation button 2.
7. After a few seconds, steam will start to come out of the steam head.
8.  It takes a few seconds for steam to enter the cleaning pad.
9. The steam mop will now glide easily over the surface to be cleaned.
10. Push and pull the steam mop slowly across the surface to thoroughly steam clean each section.
11. Wait until the steam mop cools down (approximately five minutes).

After Use

1. Turn the steam operation button 2 to Off and then press the ON/OFF button 1.
2. Wait until the steam mop cools down.
3. Unplug the steam mop from the electrical wall outlet.
4.  Empty the water tank.
5. Remove the cleaning pad 7 and wash it so that it will be ready for the next use.

Maintainance & Cleaning

Your BLACK+DECKER corded appliance has been designed to operate over a long period of time with a minimum of maintenance. Continuous satisfactory operation depends upon proper appliance care and regular cleaning.

• Clean your appliance using a soft, damp cloth.
• Never let any liquid get inside the appliance; never immerse any part of the appliance in a liquid.
• For stubborn marks, you can use a mild solution of soap and water to dampen your cloth.

Two-Year Limited Warranty

(Applies only in the United States and Canada)

What does it cover?

• Any defect in material or Black And Decker RC3303 3-Cup Rice Cooker workmanship provided; however, Applica’s liability will not exceed the purchase price of the product.

For how long?

• One year after the date of original purchase.

What will we do to help you?

• Provide you with a reasonably similar replacement product that is either new or factory refurbished.

How do you get service?

• Save your receipt as proof of the date of sale.

What does your warranty not cover?

• Damage from commercial use
• Products used or serviced outside the country of purchase
• Shipping and handling costs associated with the replacement of the unit

How does state law relate to this warranty?

• This warranty gives you specific legal rights, and you may also have other rights that vary from state to
  state or province to province.

Customer Service

• Website: https://support.blackanddecker.com/
• Timings: Monday–Friday, 8:00 a.m. – 5:00 p.m.
• Ph: +1-800-544-6986

FAQs

Q: Can I add cleaning solutions, vinegar, or fragrance oils to the water tank?

No, just use water. Chemicals, fragrances, and cleaning products might harm internal parts and nullify the warranty.

Q: How long does it take for the mop to produce steam?

After being plugged in, the HSM13E1 typically heats up in 20 to 30 seconds. You can start mopping as soon as the indicator light indicates that it’s ready.

Q: How long can I clean on one tank of water?

Depending on your consumption and steam intensity, a full water tank can offer up to 20 minutes of continuous steam.

Q: How do I clean or replace the microfiber pad?

After allowing the mop to cool fully, use the Velcro or clip method to remove the pad. Wash it by hand or in a washing machine using warm water and a moderate detergent. Before using it again, let it air dry completely. Steer clear of fabric softeners and bleach.

Q: Is it safe to use tap water?

To avoid mineral buildup inside the unit, it is advisable to use distilled or demineralised water if you live in a hard water location. To maintain performance, clean the mop’s water system on a regular basis if you must use tap water.

Q: Can I use the steam mop to sanitize?

Indeed, when used properly and without the use of chemicals, the HSM13E1 can eradicate up to 99.9% of bacteria and germs on sealed hard surfaces. Let the steam remain on each region for a few seconds to ensure thorough sanitisation.